Bloom Yellow Bottles

Grower Handbook · Chapter 09

Climate and Light: DLI, PPFD and VPD explained.

Light is the engine and humidity decides how easily the plant can use it. Here is how daily light is counted, what one controlled cannabis study found as light went up, and what VPD is telling you.

US Edition · Free download · Sources kept
Dark soil with fine white roots, the Bloom Grower Handbook chapter on climate and lightBloom Grower Handbook · Chapter 09

Key takeaways

  • DLI is light intensity times hours. 600 µmol for 12 hours is about 26 mol/m²/day.
  • In one cultivar, flower weight kept rising in a straight line from 120 to 1,800 µmol, and potency per gram did not move.
  • VPD of 0.7 to 1.5 kPa is the moderate target for greenhouse crops. Very low VPD slows uptake.

What one light trial found

Cannabis is one of the few crops with a clean light-response trial. Dry flower weight rose in a straight line as canopy light went up and did not level off in the range tested.1 Leaf photosynthesis did level off well before that. The canopy kept adding weight anyway.

4.5×
dry flower yield from the lowest to the highest light level in the study.
One cultivar (‘Stillwater’), 12/12, 81 days. Cannabinoid concentrations did not change with light.1
Canopy light (µmol/m²/s)Dry flower (g/m²)DLI at 12 h (mol/m²/day)
120116about 5
1,800519about 78

The study tested 120 to 1,800 µmol/m²/s. The two end results are shown; the authors describe the response as linear.1

What it did not test

Energy use was not measured, CO₂ and light were not combined, and only one cultivar was grown. Total terpenes rose from 8.85 to 12.7 mg/g, but most individual terpenes did not change.1

Counting light: PPFD and DLI

DLI is the light plants receive in a day: intensity times duration. Greenhouse values seldom top 25 mol/m²/day, and glazing and structure can cut outdoor light by 40 to 70%.2

StepNumber
DLI formulaPPFD × hours × 0.0036
600 µmol for 12 h600 × 12 × 0.0036 = 25.9 mol/m²/day (about 26)
1,800 µmol for 12 hAbout 78 mol/m²/day

VPD: humidity that makes sense

Relative humidity changes meaning with temperature. VPD, the pull the air puts on a leaf, does not. At zero the air is saturated and nothing is pulled; as it rises, the plant and the substrate lose water faster.3

VPD bandWhat extension says
Below 0.3 kPaVery low. Little water movement, little nutrient uptake. Right for rooting cuttings, not for rooted plants.3,4
0.7–1.5 kPaModerate. A target for greenhouse crops.3
Above 1.5 kPaHigh. Water loss is high and photosynthesis of some crops can fall.3
About 0.3 kPaRecommended early in rooting cuttings.4

The source also names a band between 0.3 and 0.7 kPa that the text we read does not describe, so it is left blank. There are no cannabis stage-by-stage VPD targets in the research we could open.3

Light, climate, feed

More light means a bigger demand for water and nutrient. Chapters 04 and 07 cover the pH and EC side. Bloom’s feed charts do not change with your light, so read your plant and your numbers.

Keep notes

Log PPFD, hours, temperature, RH and what you fed. Change one thing, wait, and compare.

What one grower said

“The Yellow Bottles plant is really showing off.”

@therealbestbudz Products named: Ultra. In the grower’s own words, from a DM, written in the second week of flower. One grower’s view, not a measured result.

Other crops: growing fruit, veg, peppers or ornamentals? Rates and the feed schedule are on the fruit and veg feed schedule page. This handbook prints no crop rates.

Honest check

  • The light study used one cultivar in one indoor setup. It says what happened there, not what will happen in your room.
  • VPD bands come from greenhouse extension guidance, not cannabis trials.

Sources

  1. Rodriguez-Morrison V, Llewellyn D, Zheng Y (2021). Cannabis yield, potency, and leaf photosynthesis respond differently to increasing light levels in an indoor environment. Frontiers in Plant Science 12:646020. doi.org/10.3389/fpls.2021.646020
  2. Torres AP, Lopez RG. Measuring daily light integral in a greenhouse. Purdue Extension HO-238-W. ag.purdue.edu
  3. Runkle E (2021). Water vapor-pressure deficit. Michigan State University Extension (Greenhouse Product News). canr.msu.edu
  4. Runkle E. Propagation pointers; Improve rooting of cuttings; Indoor propagation. Michigan State University Extension. canr.msu.edu

Go deeper

Questions growers ask

What is DLI and how do I calculate it?
DLI is the light plants receive in a day: PPFD times hours times 0.0036. For example 600 µmol for 12 hours is 25.9 mol/m²/day.
How does more light change cannabis yield?
In one indoor LED study of one cultivar, dry flower weight rose in a straight line from 116 g/m² at 120 µmol to 519 g/m² at 1,800 µmol, about 4.5 times. Cannabinoid concentrations did not change with light.
Did the light study measure energy use?
No. Energy use was not measured, CO₂ and light were not combined, and only one cultivar was grown.
What is VPD?
VPD is the pull the air puts on a leaf. At zero the air is saturated and nothing is pulled; as it rises, the plant and the substrate lose water faster.
What VPD should I run?
Extension gives 0.7 to 1.5 kPa as a moderate target for greenhouse crops, and about 0.3 kPa early in rooting cuttings. There are no cannabis stage-by-stage VPD targets in the research we could open.
Do Bloom feed charts change with my light?
No. Bloom’s feed charts do not change with your light, so read your plant and your numbers and log what you change.

Download the full Grower Handbook (PDF, US Letter)

Questions on your grow? Talk to Nate.

Product images are renders. Stage and cover images are a mix of AI-generated illustrations and photos, used to show how things work, not results. This is general growing information for legal crops. Follow your local laws and the product label. Bloom products are plant nutrient additives. They are not pesticides and are not certified organic.

New to Bloom? Your one-time 30% thank-you is waiting.One-time 30% for first-timersClaim my 30%