Bloom Yellow Bottles

Grower Handbook · Chapter 08

Runoff and Dry-Down: how to take a PourThru sample.

What drains out of the pot tells you what the roots are sitting in. Here is how to catch a sample, which EC numbers extension services give, and what a dry-down is.

US Edition · Free download · Sources kept
Dark soil with fine white roots, the Bloom Grower Handbook chapter on runoff and dry-downBloom Grower Handbook · Chapter 08

Key takeaways

  • Check pH and EC regularly, before a problem shows, and write the readings down.
  • The easiest test: water the pot, wait an hour, pour distilled water through, measure what drains.
  • One controlled dry-down trial exists, but we have not opened it, so there are no dry-down numbers here.

Read what comes out, not just what goes in

The feed you mix and the solution at the roots drift apart as salts build up or get used. Extension services say to check substrate pH and EC routinely, before nutrition problems show, and to log the readings over time.1

EC targets by sampling method (greenhouse crops, mS/cm)

Crop typeSaturated extractPourThru
Low-salt crops0.76–21–2.6
Heavy feeders2–3.52.6–4.6

Chrysanthemum and poinsettia are the heavy-feeder examples in the source. These are greenhouse floriculture targets, not cannabis targets, and the two methods read differently, so compare like with like.1

Watch the trend

A weekly record shows EC creeping up or pH drifting well before the plant complains. In one extension example, a clear-water application brought a climbing EC back down from about 4.0 to 3.0 mS/cm.1

Mind the water

High water alkalinity can push substrate pH up over time, and high substrate pH can cause iron deficiency. Get your irrigation water tested before you start.1

How to take a sample

  1. Water as normal. Irrigate the pot as part of your usual feed.
  2. Wait an hour. The test is run about an hour after irrigation.2
  3. Pour distilled water through. Pour evenly over the surface and let it drain about 10 minutes into a saucer.2
  4. Measure the drainage. Read pH and EC with a meter that reads both, then log them.1,2
DetailFigure
Leachate to collectAbout 50 ml, or 2.5% of the container volume in larger pots2
Containers in the Purdue test4 to 38 L (about 1 to 10 US gal, converted)2
Weeks the pH reading stayed consistent5–102
MeterReads both pH and EC, temperature compensated2

Samples are specific to crop type, container size, substrate and feed type.1

What a dry-down is, and where Bloom fits

A dry-down is a planned period where the pot is allowed to dry before the next feed, instead of staying wet. One controlled trial of a late-flower dry-down exists in the journals. We have not been able to open it, so there are no dry-down figures in this handbook.

Bloom and runoff

Bloom’s bottles go in the feed, so your runoff numbers include them. Mix, check pH, read the EC, and use the chart for your medium. This chapter sets no rate. Chapters 07 and 04 cover the water and chart side.

What one grower said

“Cant wait to do some side by side next run!”

@greenmedsgarden Products named: Ooze. In the grower’s own words, from a DM. One grower’s view, not a measured result.

Other crops: growing fruit, veg, peppers or ornamentals? Rates and the feed schedule are on the fruit and veg feed schedule page. This handbook prints no crop rates.

Honest check

  • These are greenhouse floriculture methods and targets. Cannabis rooms differ, so use them as a method, not a target.
  • We left out the dry-down study’s figures because we could not open the paper.

Sources

  1. Camberato D, Lopez R, Mickelbart M. pH and electrical conductivity measurements in soilless substrates. Purdue Extension HO-237-W. ag.purdue.edu
  2. Purdue and Michigan State Extension. Measuring pH and EC of crops grown in large containers (PourThru method). canr.msu.edu
  3. Gallon conversions are arithmetic (1 US gal = 3.785 L).

Go deeper

Questions growers ask

Why check runoff?
The feed you mix and the solution at the roots drift apart as salts build up or get used. Extension says to check pH and EC routinely, before nutrition problems show, and to log the readings.
How do I take a PourThru sample?
Water as normal, wait about an hour, pour distilled water evenly over the surface, let it drain about 10 minutes into a saucer, then read pH and EC with a meter that reads both.
How much leachate do I need?
About 50 ml, or 2.5% of the container volume in larger pots.
What EC should my runoff read?
Extension greenhouse targets: low-salt crops 0.76 to 2 mS/cm by saturated extract and 1 to 2.6 by PourThru; heavy feeders 2 to 3.5 and 2.6 to 4.6. They are floriculture targets, not cannabis targets, and the two methods read differently.
What is a dry-down?
A planned period where the pot is allowed to dry before the next feed, instead of staying wet. One controlled late-flower trial exists, but we have not opened it, so this handbook prints no dry-down figures.
Does Bloom change my runoff numbers?
Bloom bottles go in the feed, so your runoff numbers include them. Mix, check pH, read EC and use the chart for your medium. This chapter sets no rate.

Download the full Grower Handbook (PDF, US Letter)

Questions on your grow? Talk to Nate.

Product images are renders. Stage and cover images are a mix of AI-generated illustrations and photos, used to show how things work, not results. This is general growing information for legal crops. Follow your local laws and the product label. Bloom products are plant nutrient additives. They are not pesticides and are not certified organic.

New to Bloom? Your one-time 30% thank-you is waiting.One-time 30% for first-timersClaim my 30%