Bloom Yellow Bottles

Grower Handbook · Chapter 12

Nutrient Deficiency Troubleshooting: a calm order of checks.

Before you change the feed, work out what the plant is telling you. A calm order of checks: where the symptom shows, whether it is symmetrical, what the pH is doing, and what a test says.

US Edition · Free download · Sources kept
Dark soil with fine white roots, the Bloom Grower Handbook chapter on troubleshootingBloom Grower Handbook · Chapter 12

Key takeaways

  • Old leaves first points to a mobile nutrient. New growth first points to an immobile one.
  • pH can lock a nutrient out of reach even when plenty is in the water.
  • Change one thing at a time, and keep notes.

A calm order of checks

  1. Look. Which leaves show it first, old or new? Is it spread evenly across the plant, or patchy?
  2. Check the water. Measure the pH and EC of the feed and of what drains out. Is the pH inside your window?
  3. Test. A media or soil test, and a tissue test when symptoms look alike.1
  4. Change one thing. Adjust one variable, note it, and give the plant time before the next move.
Where it shows firstPoints to
Old leaves firstMobile nutrient: nitrogen, phosphorus, potassium or magnesium.1
New growth firstImmobile: calcium, copper, boron, iron, manganese or zinc.1

Deficiency symptoms tend to spread symmetrically across the plant; biotic problems tend to look patchy. Symptoms can also be mistaken for pesticide drift or disease.1

pH too low

Iron and manganese can reach toxic levels,2 and calcium and magnesium may run short.3

pH too high

Iron, manganese, zinc and boron can become unavailable,1 and high-pH deficiencies are often tied to very alkaline water.2

Symptom lookup

NutrientMobilityShows first inSymptom named in the source
Nitrogen (N)MobileOlder leavesOlder leaves yellow
Phosphorus (P)MobileOlder leaves—
Potassium (K)MobileOlder leaves—
Magnesium (Mg)MobileOlder leaves—
Calcium (Ca)ImmobileNew growth—
Boron (B)ImmobileNew growthDistorted, misshapen new leaves
Iron (Fe)ImmobileNew growth—
Manganese (Mn)ImmobileNew growth—
Zinc (Zn)ImmobileNew growth—
Copper (Cu)ImmobileNew growth—

Sulfur and molybdenum were not placed by the source. It describes only nitrogen and boron symptoms in words, so the rest are shown by location only.1

What to do first

  1. Do not chase it with the feed. A feed problem and a pH problem look the same. Check pH and EC before you add anything.
  2. Look at the pattern. Even across the plant points to nutrition. Patchy points elsewhere.
  3. Test. Substrate or soil test; tissue test if symptoms look alike.
  4. One change, then notes. Date it, note it, and wait before the next move.
MediumpH guidance
Soilless mediaOptimal substrate pH for most greenhouse crops is 5.4 to 6.4; peat and bark start at 3 to 4 and are limed up into range.2
HydroOklahoma State puts the nutrient solution at pH 5 to 6 (usually 5.5) and the root zone at 6 to 6.5.4

More on the numbers: Chapter 07, water, EC and pH.

What one grower said

“when I transplanted them I watered in some roots and sea minerals and there was Zero signs of shock/setback!”

@bige Products named: Roots, Sea Minerals. In the grower’s own words, from a DM. One grower’s view, not a measured result; check your own water and pH.

Other crops: growing fruit, veg, peppers or ornamentals? Rates and the feed schedule are on the fruit and veg feed schedule page. This handbook prints no crop rates.

Honest check

  • This chapter is general extension guidance for greenhouse and ornamental crops, not a diagnosis of your plants.
  • If something looks wrong and the checks do not explain it, send a photo and your numbers.

Sources

  1. Shober AL, Denny GC. Identifying nutrient deficiencies in ornamental plants. University of Delaware Cooperative Extension. udel.edu fact sheet
  2. Lindberg H, Owen WG (2018). Managing substrate pH of soilless substrates. Michigan State University Extension. canr.msu.edu
  3. UMass Extension Greenhouse Crops and Floriculture. Soil test report, commercial floriculture. umass.edu fact sheet
  4. Singh H, Dunn B. Electrical conductivity and pH guide for hydroponics. Oklahoma State University Extension. extension.okstate.edu

Go deeper

Questions growers ask

Do old leaves or new leaves show a deficiency first?
It depends on the nutrient. Nitrogen, phosphorus, potassium and magnesium are mobile, so older leaves show it first. Calcium, copper, boron, iron, manganese and zinc are immobile, so new growth shows it first.
How can I tell nutrition from a pest or disease problem?
Deficiency symptoms tend to spread symmetrically across the plant; biotic problems tend to look patchy. Symptoms can also be mistaken for pesticide drift or disease, so test.
What should I check before changing the feed?
Measure the pH and EC of the feed and of what drains out. A feed problem and a pH problem look the same, and pH can lock a nutrient out even when plenty is in the water.
What happens if pH is too low or too high?
Too low: iron and manganese can reach toxic levels, and calcium and magnesium may run short. Too high: iron, manganese, zinc and boron can become unavailable.
What test should I run?
A media or soil test, and a tissue test when symptoms look alike.
Why change only one thing at a time?
Because you can only learn from a change you can pin down. Date it, note it and give the plant time before the next move.

Download the full Grower Handbook (PDF, US Letter)

Questions on your grow? Talk to Nate.

Product images are renders. Stage and cover images are a mix of AI-generated illustrations and photos, used to show how things work, not results. This is general growing information for legal crops. Follow your local laws and the product label. Bloom products are plant nutrient additives. They are not pesticides and are not certified organic.

New to Bloom? Your one-time 30% thank-you is waiting.One-time 30% for first-timersClaim my 30%